Buy or Renew
Buy or Renew
avilt
Level 3
Level 3
Member since ‎04-13-2004
‎05-12-2021
Recent Badges
Awards

User Statistics

  • 538 Posts
  • 0 Solutions
  • 107 Helpful votes Given
  • 41 Helpful votes Received
Recent Badges
See all
70 Discussion Posts
60 Replies
40 Discussion Posts
350 Discussion Posts
400 Discussion Posts
40 Helpful Vote
40 Replies
300 Replies
300 Discussion Posts
450 Discussion Posts

User Activity

Switching Advice

05-11-2021
I have a requirement to implement routing among 3 locations as shown in the following diagram. Location A.B & C are in a unique subnet in default vlan1. I cannot make any changes on these networks (A, B & C) because it's not under my control. Now I a...

Clock is unsynchronized, stratum 16, no reference clock

04-04-2021
I have setup 9300 switches, the IP is defined only on MGMT interface. But the time sync fails, I have other devices which are getting time from the same NTP server. Any advise. MGMT01#show running-config | include ntpntp source GigabitEthernet0/0ntp ...

VTY Session Timeout

04-03-2021
I have defined VTY 0 15 timeout, my SSH session is on MGMT (out of band) interface and vty timeout is not working. How do I enable it for MGMT as well?

Cisco Switch MGMT Default Gateway

03-26-2021
On a Cisco switch, if I define MGMT out of band IP address, how do I define the default gateway for it which should remain out of band? Example: I have a 9300 switch with two vlans 192.168.1.x & 192.168.2.x with vlan IP interfaces and also a default ...

9300 SNMP Management

03-26-2021
I have configured 9300 switch with management on MGMT port. No IP defined on vlan or physical interfaces.I have configured snmp V3 and I am unable to monitor the switch using my NMS software. Is there any specific setting need to be defined to monito...
View more
Community Statistics
Member Since ‎04-13-2004 03:30 AM
Date Last Visited ‎05-12-2021 12:53 AM
Posts 538
Total Helpful Votes Received 41