cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
414
Views
0
Helpful
4
Replies

9300 SNMP Management

avilt
Participant
Participant

I have configured 9300 switch with management on MGMT port. No IP defined on vlan or physical interfaces.

I have configured snmp V3 and I am unable to monitor the switch using my NMS software. Is there any specific setting need to be defined to monitor on MGMT interface?

4 Replies 4

Seb Rupik
VIP Advisor VIP Advisor
VIP Advisor

Hi there,

Have you appended all of your snmp-server statements with use-vrf Mgmt-vrf  ?

 

cheers,

Seb.

please provide the commands.

 

I have defined the following

 

SNMP-Server group TestSNMPv3Group v3 priv Read TestSNMPv3View Write TestSNMPv3View
SNMP-Server group TestSNMPv3Group v3 priv context vlan match prefix
SNMP-Server view TestSNMPv3View Internet included
SNMP-Server user TestSNMPv3User TestSNMPv3Group v3 auth SHA 1q2w3e4r priv AES 1q2w3e4r

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - You may also have some manual snmp v3-based command line testing , before using the NMS.

 M.

 

I found similar problem on the following link, is it still not resolved on 9300?

https://community.cisco.com/t5/mpls/snmp-access-to-interface-in-vrf-mode/td-p/486197

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers