Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Had problem with CPU utilization in cisco 4500 (CATOS).
Every 2 minutes CPU utilization 60-70% for few seconds then decline to normal CPU utilization its about 15%.
show process cpu sorted showed that
K2AclCamMan Audit re process takes 60%.
What t...
HiI configure intervlan on cisco 7613 (2vlans on one port).There are 2 vlans (vlan 10 and 20)Users in vlan 10 cannot communicate with users in vlan20. I did successfully this configuration in many routers. But it doesn work in cisco7600 on ES+ card....
Hi all.I have problems with BGPSay there 2 routersr1---------r2In r1 I have route 192.168.0.0/24 with AS path (24721 65000 500)r2 have the same route with AS path (24720 24721 65000 500) I want that r1 advertise 192.168.0.0/24 to r2 with its own AS o...
Hello GuysI have one great problem. So We have Cisco SCE1010 and we have Monitoring Server. From Monitoring Server I wanna query SCE 1010 by this command:snmpwalk -v2c -c public 192.168.192.2In response: Error: OID not increasing: RFC1213-MIB::atIfIn...
Hi guys.SCE#show system operation-status System Operation status is WarningDescription: 1. Problem detected in a power supply2. HW failure due to line feed problemPort status is:Link on management port #1 is down2. HW failure due ...
Yeap! Two users connected to huawei switch.show inter trunk output in ciscoPort Mode Encapsulation Status Native vlanTe12/1 on 802.1q trunking 1Port Vlans...
