Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Previously I use CUCM to provision user services. All users are LDAP Sync, and I have 3 LDAP Directories because of 3 OU.
Example : OU=groupa,DC=client,DC=com / OU=groupb,DC=client,DC=com / OU=groupc,DC=client,DC=com
Now I use PCP with LDAP sy...
Hello,
I've an issue on Unity Connection 11.5.
When I provision services for an user in Prime 11.5, he appears on the CUCM as LDAP Sync User which is good.
But he appears as "This user is integrated with a Cisco Unified Communications Manager end use...
Hello,
I have 3 MST Regions with different instance/vlan mappings.
However, some vlan-ID are common in different regions.
For example : vlan 10, instance 1, region A & vlan 10, instance 3, region B
If I connect two switches in different regions, and ...
Hello,
I need to convert 2* 4500X from standalone to VSS, in a network production, and during business hours.
I didn't found any documentation, but I found the 6500 one, so I will use it and adapt.
But I have one question :
If I begin to convert firs...
Hello,
I just upgrade be6k from vmware 5.0.0 to 6.0u2
I plan to upgrade cucm/cup/cuc from 9.1 to 11.5
I would like to know if I need to upgrade virtual machine hardware from 8 to 11??
What are benefits/risks balance ?
Thank you!!
Hi,
Migration is done without any downtime.
However, the standby chassis did not shutdown its ports when joining VSS for the first time.
It had no impact because access uplink ports have strong config, but it could be bad if trunk negociation is acti...
Hello,
I plan to configure VSL just before rebooting in VSS mode, as 6500 doc says. (I just wrote global actions in my last message)
Next, when sw1 reload in vss mode it will rename its ports but keeps config. So no impact on access switch.
However, ...
Hi Reza,
As it is an hospital, there is no non-business hours or planned maintenance.
I decide to migrate with following action plan :
- Reload chassis #1 in VSS Mode (no service disrupting as chassis #2 continue to work)
- Reload chassis #2 in VSS M...
Ok I guess Cisco will not ask for 4000GB memory in its VM. Uh, finally I'm not sure....
So I will keep backward compatibility with vm8 version, because I don't want change hardware for fun, Vxnet3 adapter is enough deep change for today.
Thanks.
