Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,using jtapi when i receive call i have On incoming callReceived--> Terminal/(P1-callProxy) [BOT3473499480] CiscoTermDeviceStateAlertingEv [#7] Cause:100 CallCtlCause:0 CiscoCause:0 FeatReason:12 DEVICE STATE--> ALERTINGwhen answerReceived--> Termi...
Hi,i have one sip phone connected to cucm 12.0 , i have created an SIP Normalization Script attached to an sip profile.Function in M.outbound_INVITE seem to work correctly, but function M.inbound_INVITE not trigger.There is a limit in this?I have mak...
Hi,
we have to make two vpn in overlapped network, example:
My lan
192.168.0.0/24
Remote1
192.168.0.0/24
Remote2
192.168.0.0/24
I have control only in my side of vpn, Remote1 and Remote2 can't make nat or change in firewall.
I have an Asa 9.1
...
Hi,I would try cisco jabber on cucm 8.6, was are solutions to make sure the publication of cucm the internet?What are the various solutions cisco?Thanks
Hi,we are planning to migrate from cucm 6.1 to 8.6 in vmware.My question is, how do you port dlu from 6.1 to 8.6 ?Just ask licensing@cisco.com to rehoming dlu in virtual mac address?And which product code should I buy for the 8 cm software?If instead...
In all example i see, i see to make a source nat to match traffic selection but in my case in inpossible...
I neet to make destination nat after ipsec , to specify natted address in my ipsec traffic selection
Thanks Srini,another question, if we migrate to UCL i need only MIG-CUCM-USR-A?When cucm 9 is released, i can porting this ucl to version 9? ucl are perpetual as dlu?Thanks
