About mmuellerde

mmuellerde · 08-23-2013

Hello *,actually I'm trying to track down and identify serious STP loop problems at my SG300-xy switch tree.For further investigation I would like to use the debug-mode of the CLI but unfortunately thedebugcommand of the debug-mode is password protec...

mmuellerde · 07-31-2012

Dear Cisco community,as my Netgear FVX538v2 router recently died I would like to replace this router by an enhanceable Cisco product. I'm thinking of a Cisco 2901 model that will be connected to the cable modem of my ISP and has to support PPPoE over...

mmuellerde · 11-14-2013

Hello *,just an additional question on how to do the firmware upgrade to 1.3.5.58:After upgrading the boot code do I first have to reboot the switch before copying and applying the firmware upgrade to the switch?Or is it essentional NOT to reboot and...

mmuellerde · 08-24-2013

Hello Tom,ok, many thanks. If it voids guarantee I better won't touch the debug engine.Then let's discuss discovering and resolving STP issues of my SG300-52 switch installation.I'll later come back with a seperate posting on my recent STP issues.Bes...

mmuellerde · 08-24-2013

Hello *,even while the debug mode may be "unsupported" it isn't possible to simply pull the plugs to analyze STP problems.So I'm still looking forward to any option how to enter the SG300-xy debug mode by providing a valid password to the debug comma...

Member Since	‎07-31-2012 11:42 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	5

User Statistics

User Activity

How to track down STP issues with SG300-52 and SG300-28 - password of debug-mode debug command?

Replacement of Netgear FVX538v2 with Cisco Router 29xx?

Re: Firmware upgrade 1.3.0.62 --> 1.3.5.58 (SG 300-28P)

Re: How to track down STP issues with SG300-52 and SG300-28 - pa

Re: How to track down STP issues with SG300-52 and SG300-28 - pa