Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On a specific Floor we have numerous 9120 AP's and 1 x AP in particular is showing 95% of its clients with very low data rates of under 69Mbps. The AP is automatically setup to adjust its power rating and currently its level is 1/8 ( 23dbm ) which i...
Hi we currently have a situation in our Company where we have a community Social Hub area and some 3rd Party clients would like to connect in there own WIFI AP to then give some of there own devices wireless access out via there WIFI AP and then via ...
Hi Community, I am trying to restrict internet only access for a specific vlan e.g ( 620 Vlan - 172.16.62.0/24 ) but when l apply the following access lists to the 620 Interface response time seems to be very slow ? If l remove the specific access-l...
Hi I have a Linksys RV042 10/100 4-Port VPN Router with Firmware Version 1.3.13.02 and l have noticed that the Router keeps rebooting on average every couple of hours.. We have it setup for Load Balancing 2 ADSL Services..Any assistance with the rou...
Hi,Currently l have two ASA 5520's in a active/passive failover scenario. Currently the interfaces for the inside and outside are fixed at 100/FULL.I want to repatch them into GigE ports setup as Auto Negotiate.Is there anyway of keeping the connect...
HI Gaurav.. We recently did a site survey and from this we reconfigured our WLC from 80mhz back down to 20Mhz for 5Ghz as we were seeing high utilization and interference.. Going to 20Mhz gives us more channels for our 5Ghz clients and around 280Mb...
I am actually seeing certain clients when roaming to another AP of the same model ( 9120 ) that there Data rate increases to 287Mbps so l think it more to do with that AP in question..
