Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hiI hope you can help, I have a Cisco Core 3750 which is hosting all the SVI for Server, Storage, Firewall, ISP, there is anotherset of 3850 switches connected which is hosting the SAN. Cisco 3750 - 192.1.1.217, 10.70.0.254, 10.11.0.254Cisco 3850 - 1...
HiI hope you can help. I currently have a task of migrating to new ISP. We have a Cisco ASA 5508, (ASA 9.7), three interfaces - inside, DMZ and Outside. I need to migrate from the current ISP1 to two new service providers BT and TalkTalk. But i will ...
hello
I hope you can help, we have an ASA 5550 model, and SSH & ASDM have been working fine for years now. But all of a sudden they have stop responding.
The firewall itself is working and still routing traffic to the internet. No ACL were changed...
Hi
I hope you can help, can you please advice what the best way to calculate the no of APs required for lets say 200 users with 2 devices per user.
Please let me know what formulas would apply.
many thanks
Hello
I hope you can help me with VLAN config on a cisco 3750 switches.
We have two office connected with a BT LES link (point to point). With 3750 switches in both offices, and two HyperV servers, one in each office.
Both HyperV servers have an iso...
Hello Deepak PO 6 - this etherchannel is for the edge switch, mainly our office area. vlan 26 is the office lan. Po40 - SAN is on VLAN70, which I have trunked across both set of switches.Everything before VLAN 70 is to do with servers, SAN, vmware et...
hello As requested below is the out from the Cisco 3750 and the Cisco 9300 switch cisco 9300 config HAM-001-FP-Core-S1#sh ip routeGateway of last resort is 192.1.1.151 to network 0.0.0.0S* 0.0.0.0/0 [1/0] via 192.1.1.151192.1.1.0/24 is variably subne...
helloSorry what i meant is that is it ok to setup all three ISP interfaces (current ISP, BT and TalkTalk) to Security Level 0.There are additional interfaces on the ASA - Inside and DMZ.I am trying to do some prep work for the ISP migration, I was go...
Thank you Dennis for the response. So I can setup all three interfaces with Security Level 0 ? The plan is to cease the current ISP. Make the BT circuit the primary circuit and Talktalk as the secondary (manual failover).On the ASA I have several int...
