Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have updated our customer wireless network with new 1562I and 1562D access points. We have diverse clients that wok fine, but we are facing some connection problems with third party clients used as wgb, wlc fail to comunicate randmly and shows err...
Hello, we have two radius servers <Radius_1_PUBLIC_IP> and <Radius_2_PUBLIC_IP> When the first shuts down, the AS5300 Gateway does not change to the backup server.aaa group server radius H323-calls server <Radius_1_PUBLIC_IP> auth-port 1812 acct-port...
Hello, I have the next problem: I've configured a ft group between two ACEs. The active ACE works ok but if the standby ACE becomes active, it doesn' work (I cannot reach port 80).What could this be? Configs are synchronized and I have checked physi...
Well, the use of external antennas is needed because of the size of vehicles, this is a must and have already been tested. We have also check the network performance, survey, channels, etc. Radio parameters are not the problem as the network is corre...
Yes we have some aps to test, but the problem is that our customer is in a very difficult enviroment, so testing in it's production network is not easy. What i was trying to find is what would be the idoneus AP to test and if there were any know issu...
Rigth now, we have mikrotik AP acting as station pseudobrige, what we want to do is change all this mikrotik aps devices acting as clients with Cisco aps acting as a WGB.We have 5508 on 8.5.120.0
Hello, thank you very much for the response.We have tried to configure a global shared key and local shared key:radius-server host auth-port 1812 acct-port 1813 non-standard key 7 radius-server host auth-port 1812 acct-port 1813 non-standard key Bu...
