Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have this current issue with MAC_MOVE:Nexus 5548 currently shows: SWC01 %FWM-6-MAC_MOVE_NOTIFICATION: Host 02a0.98ab.7593 in vlan 120 is flapping between port Eth1/13 and port Eth1/15SWC01 %FWM-6-MAC_MOVE_NOTIFICATION: Host 02a0.98ab.7593 in vlan ...
I have configured RAVPN and I am trying to access the outside of the firewall to download the VPN client. I put in the url setup to access to outside interface of the firewall but can't get any reply. I am pretty sure I have everthing configured as r...
I am facing an issue with integrating a new customer, Customer B, into our network. They have developed a virtual system that uses the same IP addresses as another one of our customers, Customer A. Customer B mentioned that it would take a significan...
I am being required to implement FIPS mode on the Cisco FMC/FTD. We are also required to use PKI for authentication onto the devices. We have the FMC asking for CAC cert and PIN but keep getting ERR_BAD_SSL_CLIENT_AUTH_CERT.Any suggestions on where t...
Just an update on this issue... I can now hit my firewall from outside the .mil network. I configured a flexconfig to disable the webvpn but I still don't know why I am not getting the page to download the client.Any suggestions on where to look for ...
Well we have figured this one out for the no scan issue. There was a NAT policy that was natting the outside interface address to some internal ip addresses.. When it was configured, it should have been set as a PAT. Fixed this and now NOC can scan o...
I need to open the outside interface so that the Cyber team from the ISP can scan it. I thought I had it configured but it is not allowing them to scan. Any suggestions on configuring the access policy to allow specific ip addresses to scan my outsid...
