Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Has anyone seen this and have a work around for it? I just deployed several ASA-5506 firewalls with just a basic setup for internet access and vpn to office. They work fine with my Linux laptop i get an address and can surf etc. When i plug i...
I've got a 2951 router running the 15.0(1r)M13 code train and it seems to be very flaky when using ospf and eigrp on the same router compared to some 12.3-4 code trains. Has anyone else see this weird behavior? What is the most stable 15.0 or 15.1 co...
Has anyone setup basic LAM (Local Area Mobility) I have read a few different white papers on the setup and tried it in a lab with no success at all.I've set ip mobile arp on the interface and enabled proxy-arp on it as well. I went ahead and setup re...
I have a fairly simple setup with BGP i have 2 routers running bgp as a distribution layer. These 2 routers are peering with an access layer.The access layer routers are all running a private as and peer with the via ebgp to the distribution layer ro...
Thank you for the reply! I did just find the issue!. Looks like a proxy-arp problem. Here's what I found.
If I connected via Linux, windows 8 it worked fine! If I connected via windows XP, 7 OR 10 it would fail to get an ip address. I found some refe...
Steve,Yes i could see some environments using the OTV option and the backend vmdk's and all storage is already replicated and local to the router. I wonder if it even works with the vm hosts as the host server tend to cache arp entries and I have not...
Steve,Thanks for the info! I think my only issue was that I dont have a route point out of the network for the /24 of that subnet. I will try this out. I dont know of any other technology like this is I've used IPSLA and conditional advertising. Do y...
My Goal was to direct inbound traffic through a preselected path to that inbound traffic paths would be predictable.With a full mesh bgp environment with multipath enabled you cannot always get that unless other factors are modified to make routing s...
