Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running IOS XR version 5.1.3 on ASR 9k and current number of controll policies is 99.When we try to add two more policies it fails with following error:!!% app-obj: Object Count exceeds maximum supported by system: Failed to add policy-map to ...
Hello all,
I would love to gather some info about subscribers via SNMP.
http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.9.786.1.1.1.1.3#oidContent
this is a lovely OID tree, which is imposs...
Hello,
I am currently setting up bng on 9k with l2-connected subscribers, session is initiated on receipt of dhcp packet. Everything works fine up to the point where asr 9k dhcp proxy has to send ACK to the DCHP request that client send after it gets...
Hello all,I have an issue with current ISG implementation on ASR 1k.We have subset of subscribers that are authenticated based on their mac address and another subset that are authenticated based on their c-vlan/s-vlan tag which is derived from nas-p...
Hello,I have two sites connected to each other with pseudowire with l2tpv3. I am able to ping hosts on both sides. My task is to stream media from one side to another. The software works, because I am able to stream with TCP (RTSP). But when I switch...
Sorry for late reply, the config was work in progress, I was just curious about limitations. Now control policies are down to minimum (little over 10). Thanks for the info.
Hello xander, unfortunately there is no way around it as of now. But staying under 100 policies total is still manageable. So I am right in assuming this is XR limitation?
Terribly sorry for replying for so long. the aggregated stats work fine, problem is pulling individual subsc data, I am busy with more pressing issues now, will look into it later again.
Thank you for clarification.As you can see from config snippet interface has ip address assigned, but it still didn't work untill I put unnumbered either in dynamic-template or in AV pair. So i guess it MUST be unnumbered?
