The Cisco software page for Sup 2T VSS 6807 code 15.5.1.SY4 has a review stating that the code is unstable with tracebacks with blade 32P10G. The notes state the SY4 uses a new FPGA process for that blade. This worries me. Has anyone tried this ...
I'm struggling to find documentation that outlines the steps needed to migrate from dual sup 2Ts to quads in a 6807 VSS (no code upgrade; just hardware addition). I expect code 15.5 to be on the device at the time. Any suggestions? thank you
Has any one run into problems with latency running Clean Access or seen any performance test reports for Clean Access? Has any one run internet gaming successfully under heavy loads?
BB I have the impression your links are for a standalone chassis. I think the VSS is a bit different. I'm assuming the new hw will drop into rommon (see table 4) https://manualzz.com/doc/17955617/virtual-switching-system-quad-supervisor-stateful-...
NickJust to play devil's advocate, I'm not sure I grasp how a "server" can be considered "stateless". The each packet still needs to be processed does it not as it passes through the server?thanksErnst
