Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi We currently run a number or pseudo wires over our MPLS network with the targets for the pwire being the loopback of the remote router. This means that our pwires re-route in the event of a primary link failure as long as there is an alternative p...
Hi We're currently about to start a HW refresh project to replace EoL N9Ks with new N9K hardware, so a like for like from the perspective of ports etc.This is for VXLAN leafs running OSPF, MPBGP and VPC. For the replacement we'd like to cause minima...
Hi I’m hoping you can help me with my understanding of IaC and in particular the pros and cons of a full IaC solution vs automating common repeatable tasks via ansible? For example if I’m building a new fabric what benefits do I get from using IaC go...
Hi We're currently deploying NDFC and as part of this I've been looking at some of the programmable reports for inventories, modules, SNs etc but the pre-defined templates don't do exactly what I want.So I was looking at the REPORT templates with a v...
HiI’m hoping you can help me.We’re currently in the process of deploying a NDFC cluster and as part of this I’m trying to understand the roles of persistent IPs for the management service under external service pools.We’re looking to do layer 3 POAP ...
HiAh, for section 3 I'd just need a single entry for next hop? I wasn't sure if I needed to add the outgoing address and the next one. So assuming its just for next hops IP?For point 4 is that a case of either config will work but "path-option 1 dyna...
Hi HaroldThanks for your help. So if I wanted to get this working from what you've added and from what I've read I think I'd need to add the following:1) Enable TE and set TE router-idrouter isisaddress-family ipv4 unicastmpls traffic-eng level-2mpls...
HiThanks for the responses.So as the network is currently deployed with MPLS it seems like RSVP-TE is worth exploring.As a bit of background on the pseudowire I don't want to failover is on two directly connected PEs. Therefore, if I wanted to set up...
Hi AshSeThanks a lot for the comprehensive response, that aligns with what I've read. Out of interest have you undertaken a HW swap using this method and if so what kind of hit do you see on end hosts, i.e. is it a sub-second thing that servers etc w...
HiThanks for the response and info.Do you have any links or documents where this behavior is explained or is this something that you've seen when deploying NDFC?ThanksMalc
