Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We normally interconnect an ethernet VLAN via a bridge-group to an ATM PVC like : interface ATM1/0.162055 bridge 10 pvc 16/2055 encap aal5snap!interface port-channel1.10 encapsulation dot1q 10 bridge 10!bridge 10 protocol ieeeThis works fine on our ...
We use Cisco ISR2 routers in large parts of our network for business customers on fiber and DSL connections. We are investigating how to implement unified communications on these routers, but the variety of interfaces, modules and licenses is pretty ...
We are running a few 7206VXR's where one of the interfaces is ATM (PA-A3) and the other is Gig Ethernet to our core. On the ATM we have several subinterfaces to customers. On the ethernet network, we use COS to mark frames with a p-bit and all is goo...
Recently, i got some hints on the forum to get my 2 ATM PVC's to bond together via bridging on a 7204VXR. This is working now and i can ping from left to right and ARP seems to work ok.Now i attached 2950's on both sides and configured a VLAN trunk o...
Hi,I'm trying to configure the following scheme :[LAN]--[CPE]-------<ATM 7200 ETH>---- |[LAN]--[CPE]-----The 2 ATM PVC's (16/2055 and 16/2056) should be bonded together to get afully transparent L2 link without any routing invol...
What is the correct procedure to replace the secondary node (rack1) with a new ASR9001 in an nV cluster? Is it ok to just power-down the node, change the serial of rack1 in the configuration and follow the procedure as described above?We are going to...
You didn't mention the wavelength on the SMF. It could be 1310 or 1550nm. For shorter links you'll need the 10G-LR. And yes, you can use both SMF and MMF in the same box as long as you use the correct optics.Sent from Cisco Technical Support iPad App
