About Alok Mohanty

Alok Mohanty · 08-17-2016

Hello Folks Is there a way to check for established CTI connectivity from CUCM to PIM. I know we can check it from the PG side using OPC and Diagnostic etc ... But is there a way to check the same from CUCM side. Thanks Alok

Alok Mohanty · 10-11-2015

Hello All We have installed CUCM in VmWare environment.To match the switch speed with that of hypervisor and CUCM , we changed mode and speed in hypervisor.However while attempting to do that in CUCM we issued the following command-> set network nic ...

Alok Mohanty · 10-11-2015

Hello All We have a CUCM single cluster integrated to ICM/UCCE.Everytime we perform any maintenance activities on CUCM/have it rebooted all the agents start receiving error "12005 - Device is not registered correctly in call manager" in the Agent com...

Alok Mohanty · 10-07-2015

Hello All In order to determine the voice quality , is it sufficient to verify "numberPacketsLost=0 jitter=0 latency=0".Secondly whats a good percentage value of (numberPacketsReceived/numberPacketsSent) ? Should this not give a quantitive measure of...

Alok Mohanty · 10-02-2015

Hello All With the existing track of Unity Certification being retired are there any new certifications being issued.If not , is CISCO planning to retire this product as well ? ThanksAlok

Alok Mohanty · 10-11-2015

Thanks Shenbagarajan Please find the network status for current setting. We are trying to set this from AUTO disabled to AUTO enabled.admin:show network eth0Ethernet 0DHCP : disabled Status : upIP Address : 10.207.10.118 ...

Alok Mohanty · 09-17-2015

Thanks Piyush This clears my first question. But for second query ... does it mean I would need to have 1 pguser per cluster ?I am pretty new to CUCM environment ... But I wonder they why we have 10 pg users (1 per pg pair) even though we have a sing...

Alok Mohanty · 07-17-2013

Thanks for your response Steve.I am planning to decommission a PG.After shutting down the PGs , I goto Router A , run the DMP , uncheck the corresponding check box and complete the setup. Now do I stop services on Side B of router before bringing Si...

Alok Mohanty · 06-11-2013

Thanks Ed and Oleg.I was said One Server with 2 instances of PG can be supported ONLY IF both Central Controller instances are in the same box.I am unable to see the logic behind this , as PG is communicating with the IP Address of Central Controlle...

Alok Mohanty · 05-08-2013

Thanks Senthil , But we get CTI Protocol version as 13 , 15 , and in 8.5 as 17 right.Is this different from CTI version.I thought these protocol versions need to match with the CTI Server versions.

Member Since	‎09-04-2007 08:17 PM
Date Last Visited	‎08-16-2018 11:32 PM
Posts	57

User Statistics

User Activity

CUCM to PIM connectivity verification

Change NIC Mode to AUTO in VmWare hosted CUCM

12005 - Device is not registered correctly in call manager

Analyzing VOICE Quality from CUCM logs

Cisco Unity Certifications

Thanks Shenbagarajan Please

Thanks Piyush This clears my

PG Decommissioning ICM 8.5

Multiple Instances Of ICM

Find Cisco CTI version