Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks
Is there a way to check for established CTI connectivity from CUCM to PIM.
I know we can check it from the PG side using OPC and Diagnostic etc ... But is there a way to check the same from CUCM side.
Thanks
Alok
Hello All We have installed CUCM in VmWare environment.To match the switch speed with that of hypervisor and CUCM , we changed mode and speed in hypervisor.However while attempting to do that in CUCM we issued the following command-> set network nic ...
Hello All We have a CUCM single cluster integrated to ICM/UCCE.Everytime we perform any maintenance activities on CUCM/have it rebooted all the agents start receiving error "12005 - Device is not registered correctly in call manager" in the Agent com...
Hello All In order to determine the voice quality , is it sufficient to verify "numberPacketsLost=0 jitter=0 latency=0".Secondly whats a good percentage value of (numberPacketsReceived/numberPacketsSent) ? Should this not give a quantitive measure of...
Hello All With the existing track of Unity Certification being retired are there any new certifications being issued.If not , is CISCO planning to retire this product as well ? ThanksAlok
Thanks Shenbagarajan Please find the network status for current setting. We are trying to set this from AUTO disabled to AUTO enabled.admin:show network eth0Ethernet 0DHCP : disabled Status : upIP Address : 10.207.10.118 ...
Thanks Piyush This clears my first question. But for second query ... does it mean I would need to have 1 pguser per cluster ?I am pretty new to CUCM environment ... But I wonder they why we have 10 pg users (1 per pg pair) even though we have a sing...
Thanks for your response Steve.I am planning to decommission a PG.After shutting down the PGs , I goto Router A , run the DMP , uncheck the corresponding check box and complete the setup. Now do I stop services on Side B of router before bringing Si...
Thanks Ed and Oleg.I was said One Server with 2 instances of PG can be supported ONLY IF both Central Controller instances are in the same box.I am unable to see the logic behind this , as PG is communicating with the IP Address of Central Controlle...
Thanks Senthil , But we get CTI Protocol version as 13 , 15 , and in 8.5 as 17 right.Is this different from CTI version.I thought these protocol versions need to match with the CTI Server versions.
