Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,We have 3 SG220 switches which randomly reboot.When monitoring these the HTTPS service will stop working then a few days later the switch will reboot itself. Its on the latest version of code and from what I can see there hasn't been any updates f...
I am using an SNMP monitoring platform to monitor many cisco asa's. Since switching using the 5506 snmp interface graphs are not working correctly.When scanning and adding the interfaces, the 'in' traffic works as expected but the 'out' traffic shows...
HI there, have 2 4500x in vss mode. both are running 3.4.2 ipbase and are running on the correct licences etc. after putting them in VSS mode the following error shows in the logs. %SW_LEVEL-6-RESULT: Operational redundancy mode is UNKNOWN, due to so...
Having problems with a brand new Cisco 3850. Crashes with a Kernel Panic error as listed below.Im raising an RMA request and sending this switch back to Cisco so they can investigate but wanted to know if anyone else has seen this or had any luck fix...
Is the IPS licence an annual subscription or do you buy the licence once and add the IPS to a smartnet contract for signature updates?I was always under the impression that the licence was valid for 12 months from date of purchase and a new licence (...
I'm still having this issue. I cant work out the cause.
I have gone as far as turning as much off on the switches as I can, removing redundant cabling, disabling spanning tree.. Feel like I'm at an AA meeting.
"Hello I'm an SG220 and its been 8 day...
I have set syslog up on the switches and am receiving nothing at the time on crash.
One thing that always happens is the https service stops working a couple of days before then the switch will restart.
I have also noticed that we stopped monitoring ...
Hi Apologies for not getting back.To fix this I had to manually accept the EULA for ipbase licence on the 4500x. After the reload everything worked correctly and I stopped getting this error.
