Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone!I bought a used router 1921 on ebay. When I power on the router the console message loops with the message:System Bootstrap, Version 15.0(1r)M12, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 20...
My problem is that the switch all of the sudden doesn't boot up anymore. The System LED constantly flashes, after probably 40-50 seconds or so it constantly lights for a second, afterwards all the lights on the ethernet ports light up for a second an...
Same here! My ASA 5506-X also died, all the lights went on... As described above, I opened the chassie, removed the cooling housing from the proc and then my friend solderd a 150 Ohm SMD resistor as mentioned and expained in previous posts and....WOU...
Hello, again everyone,
In my case I have two switches in the row and on both are AP's connected. The problem is that on the second one I can't get an IP if snooping is activated, the AP' on first are OK. SWITCHES ARE CONECTED WITH ETHER CHANNEL! Thi...
Hi everyone,would someone be so kind and describe the necessary credentials that must be set to get Jabber to work. I can connect with Anyconnect with my Galaxy Note 10.1, but I get stuck with the Jabber part. What to put in in brackets for DEVICE I...
Hello again!Did what "leolahoo" suggested, no succes! To be ohnest, I was sceptical in the start about the "air scenario", because the inside of the box router was very clean, no dust particles, anything. Anyway, removed the DRAM connection, squrted...
I tried the described procedure, but the problem is the switch doesn't even let me to trigger the startup menu! It just "jumps" over it and starts with the loading of the firmware.. See the software version beneath the SNMP?19-Jul-2012 17:55:03 ...
