Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,With the above mentioned scneario, I am unable to ping from HQ-Core to Branch Core switch for some reasons.I have attached the complete configuration of all the devices and output of each.Please help me on this issue ASAP.
Hi All,I'm doing some tesing in SFE2000P linksys switch about the TACACS authentication. I have configured the switch accodringly to point my ACS server with key string. Now, I'm able to login into the switch with TACACS account in HTTP/HTTPS only an...
Hi,I used the TFTP method, it worked perfectly.In addition to that, you have to use the ACS patch command option ONLY works..Example: acs patch install 5-5-0-46-2.tar.gpg repository testNote: You have to create a repository before applying the above...
Can someone explain, what exactly the below mentioned is referring to.When you enable LAG, you cannot create interfaces with a primary port other than 29.Thanks in advance..Manny
Hi Mohit,Thanks for your quick response...I am not able to ping the RMI address on both the Flex Controller's. I have connected the cable and tested the Layer 1 is good and followed the IP address assignment as per the document.I have attached the...
Hello Mohit,Really your video is very helpful for me to understand the actual process of enabling the AP-SSO operation.I have few questions to you....1. Is it, the Redundant management IP address is pingable?2. How to verify the port status of Redun...
