Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello, I have client MAC addresses I want to know when they connected, for how long, and when they drop off the wireless. I also would like to set up an email alert for when specific devices disconnect from the wireless network. Is this even possible...
Hi,
I installed a new 2504 WLC and new 3802i APs, however the APs are not fully functional. They keep cycling the LED RED/GREEN/BLUE which I don't even see in the troubleshooting guide. WLC running 8.3.102.0, APs connect, take a license, but none of ...
Thank you. I did find on the 2504>Management>SNMP>Trap I can configure areceiver and send all of the information to the SNMP trap receiver Ichoose. It may not be as glamorous or easy as Prime, but it should get thejob done. My last job I used Prime f...
Maybe I misunderstand the solution, but it sounds like I need Prime to do all you are saying. As I stated in my original post, I don't have Prime. Can I do this with the controller directly?
The log is very short, only 27 hours. I don't see a track b...
I read that too, but didn't see the note. Thank you for the second look!
Note: If the AP2800 and AP 3800 are powered from an 802.3af power source the LED will cycle though the colors and the radios will be disabled.
Thanks CDW for selling this to me!...
Hi Rasika,
Not sure what you want for a console output, so I posted AP run-config and show log:
Powered by a 6513
7 Policy Feature Card 3 WS-F6K-PFC3B 7 MSFC3 Daughterboard WS-SUP720
WS-X6148A-GE-45AF Line Card
Interface Admin Priority Oper Power(W...
