Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using cucm 8.6, configured a mgcp gateway and configured the fxo and fxs port(s).CLID presentation to the FXO port -> ip phones works perfectly, but the clid doesnt seem to get presented on the FXS port when debug on the gateway.Is this a know i...
I am trying to to an very easy job which i cant understand why it is not working On the router i have :ccm-manager mgcpno ccm-manager fax protocol ciscoccm-manager music-on-holdccm-manager config server 192.168.120.XXXccm-manager c...
Perhaps it has been asked before, but i cant find the correct answer right now.I have a sip account which uses authentication.An E164. Nr is associated with this so i can call-in and call out using the sip provider.As far as i know (until CUCM 8.6) d...
I have setup a WAP321 with the captive portal activated.2 WLAN networks defined, one for the Normal-user and 1 Guest-user access (with captive portal).The WAP Management is on its own vlan (vlan 1 ) , network 10.0.0.0 /24The Normal network has a diff...
We would like to make a setup where we can remotely change the Call-forward nr for a specific extention.Can somebody explain how this can be established ?Best regardsEddy Mulder
What i dont understand that during booting an ios and performing the IOS validation you are not getting a warning stating that the current rommon is outdated / not supported ... This caused me a lot of time finding the cause why a certain ios version...
I AM bouncing my head against a solid brick wall as THE solution is so simpel,and mentioned in an other Thread."Configure THE fxs port on THE gateway config on THE call-manager".For sure i Will not forgot this anymore....NeXT step is to get vic2-2fxo...
The output of debug ccm-manager events:vgw01#000952: Oct 24 21:51:41: cmapp_mgr_process_ev_active_host_failed: Active host 0 (192.168.120.xxx) failed000953: Oct 24 21:51:41: cmapp_mgr_check_hostlist: Active host is 0 (192.168.120.xxx)000954: Oct 24 2...
The issue i am facing at the moment, to be able to dialin to the SIP-DN i have to setup a fake ephone-dn otherwise when i do a show sip-us register status, i dont see the dn to be registered and when i call the DN i am not able to connect.The sip pro...
I am totally new to Cube, so i am trying to find the correct information how i need to setup cube to get it working.Currently reading all the documents available in regards of cube, but as it is the first time for me i have to use it its not as easy ...
