Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We're about to upgrade our WiFi network architecture. Currently we have a Foreign/Anchor setup for direct internet access. Is this the current Cisco recommended architecture? A colleague has suggest a new architecture removing the Anchor an...
Hi All,I'm trying to deploy a pair of C9800-CL virtual WLCs but they appear to be very buggy. for now lets focus on one problem. I've built the devices twice now with only the minimum configuration applied, enough to manage the devices and get HA w...
Hi All,I'm trying to setup a number of SSIDs between a C9800 foreign controller and a C9800 Anchor controller. I can get the first one up and running but that's it, I can't get a second one to work at all. Are there limitations on how many SSIDs ca...
Hi All,I'm looking into setting up a VXLAN between two Data centres separated by e layer 3 network. Each DC is a classic Cisco topology i.e. Core (2 L3switches), Distribution(2 switches) and Access(many). My question is is it ok to have VNIs on eac...
Hi all and thanks in advance for any advice.I have had the same issue now with two 9120AX APs where following a hard reset, pressing the reset button for longer than 20 seconds, I'm unable to login to the device either by SSH or console. Neither the...
Hi Scot,Thanks for your comments. I haven't configured multicast in the tunnel configuration; my understanding was it wasn't required. We have upgraded the physical and virtual WLCs three times and have had the same issue with all software versions...
I have a setup with a HA cluster of C9800-CL (Virtual) devices and two stand-alone C9800-L devices. I'm running 17.4.1 code so the tunnels are CAPWAP. My experience has been that once you configure the tunnels (vis the GUI), which are reasonably sim...
I thought I would post my solution so others may benefit from it in the future. The problem is to provide a Guest WLAN with multiple QoS polices so QoS could be applied to the same advertised SSID at different locations. A few points to note, and t...
Hi Scott,Our client would ideally like to have a single SSID advertised accross the entire network but requires different QoS profiles which are implemented locally to control bandwidth usage across WAN links. As the SSID is a guest network anchored ...
