About scott.braun

scott.braun · 03-16-2016

Hello all, I'm trying to figure out a way to pull back a call that's been configured to go to a T1-CAS circuit and send it to voicemail if the other side is busy or does not answer. This is a CUCM 10.5 environment, and the T1 in question will conne...

scott.braun · 03-17-2016

There wouldn't be a voicemail system on the other side, so there's no connected state, but I see what you mean about ringing/busy. That's what I expected but I was hoping I was incorrect. The only things I could think of were kludges, like routing t...

scott.braun · 03-17-2016

The far end isn't Telco, but there's not a PBX there either. It's just a device that turns the T1 into 24 individual analog lines, and I don't think it's "smart" enough to re-route a call like that. I'll have to see if the person in charge of that de...

scott.braun · 07-22-2015

From the CIMC web interface, go to Inventory, then the Storage tab, and then the Physical Drive Info tab beneath that. There should be a Drive Firmware column which lists the current version.

Member Since	‎04-03-2012 01:08 PM
Date Last Visited	‎03-05-2026 01:56 AM
Posts	4

User Statistics

User Activity

CFNA/CFB Routing for a Route Pattern

There wouldn't be a voicemail

The far end isn't Telco, but

From the CIMC web interface,