Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears I have successfully add the CUCM to ELM but when pressing the sync button it gave me ( successfully - Application Error ) , from the CUCM , no successful sync is appear !! kindly advise .
Dears when enabling multicasting on layer 3 interfaces the CPU becomes fully utilized , is there any specific configuration should be enabled to reduce this . Config :Inetface vlan 100ip pim sparse-denseip igmp version 3Inetface vlan 101ip pim spars...
DearsI am trying to configure the posture for the ISE but the result is always " Posture status : pending " and the agent can access all network resources without any problem .please help
DearsI have configured the IPS module with Setup command and have initialized it , but when i tried to access the IPS via ASA ASDM and saving any change it keeps telling me that i do not have sufficient rights ??Please check the attached and advise w...
DearsI have a new server for CUCM 8.5 and need to migrate the license from the old servers to the new ones , i have opened a case with tac and they asked be to buy software feature, i asked my sales to provide me with this software and now i have rec...
Hi AllI have the same case , i want to disable the " Please wait " message when call is being transfer to an extension not to a call handler , anyone has a solution for this.Best Regards
Same as i mentioned before , we have remote branch connected to CUCM "A" and calls from that branch coming from PSTN can reach the IVR and DTMF worksfin with it . is there anything else that i can try??
Please Find my answers below :Site A users when call Site B IVR, they hear the greeting but DTMF is not recognized hence they are unable to choose between options. Correct ? Correct1. What are the CUCM, IP IVR or UCCX/UCCE versions ? CUCM for User 7...
