Hi,I have enabled netflow on a Cisco 1800 router. All the interfaces are showing inbound and outbound traffic apart from Fastethernet 0. It is showing Traffic for inbound only.when I run show ip flow interface, I noticed that it created a subinterfac...

Hi,Our catalyst 6500 crashed.Would be grateful if someone tells me what the show log output below means?pewpsw02> (enable) show logNetwork Management Processor (ACTIVE NMP) Log: Reset count: 42 Re-boot History: Jul 19 2007 11:44:12 0, Sep 11 20...

Hi,We recently implemented cisco phones on our network.The 7912G phones patched to the 6509 module WS-X6248-TEL seems to keep going up and down a lot.The same does not happen on the catalyst 3750 platform.We are running Catos 6.4Has anyone come acros...

Router A - Site ASoftware : c3640-is-mz.123-3.bin - 12.3(3)Hardware : 3640 (3620 although I want to be able to do it with a 3620)Slot 0 and 1 are occupied with a 2FE1W (empty of wics) and a NMHDV with a VWIC-1MFT-E1, respectively.Slot 0 connects to ...

Could someone explain why it is not possible to terminate a unframed E1 (2.048Mbps) using the NM-1CE1U or NM-2CE1U network module.Surely a channelized E1 card could handle an the above circuit - has a clock source etc?Instead Cisco sell the VWIC-1MFT...