Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello my fellow network specialists an experts I need your helpI have tried to configure inter VLAN routing on Cisco 881, but I failed.Vlans were connected via trunk port which is connected with a switch. Configuring Vlan interfaces doesn't work, bec...
HelloRecently I had a task to clone Cisco 881 router, I mean I had to transfer a config from one 881 to another.However, I faced some issues with this task:SSH doesn't work after the transfer, as I understand it is required to regenerate certificates...
Thank you guys for your answers!I found the solution:In the configuration of VLAN interface it is required to addno autostateThis will enable VLAN interface even if there are no ports in it, and you can ping it.
lap@axcess.dk Thank you for your post! It helped me a lot. I have pretty much the same configuration. I added a deny rule for general overload NAT rule. Wrote a small post about it:http://philozow.com/2013/03/12/cisco-ios-policy-static-nat-with-ipsec...
