Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've seen some useful posts about NetFlow support on ASR9k line cards of Trident and Typhoon families. Like this:
https://community.cisco.com/t5/service-providers-documents/asr9000-xr-netflow-architecture-and-overview/ta-p/3137096 (from 09-26-2012...
Hello,
I see there are some CGN capabilities on Tomahawk generation Line Cards. CGN Licenses for 4-Port and 8-Port are orderable.
There are also some hits that some other nat-related features are supported on some other Tomahawk line cards, e.g. MA...
Hello,
I am trying to find out, what are 4 SFP+ ports on RSP880. Can they be used for traffic. Do they have any limitations? If router is equipped with 2 RSPs, may both RSPs use their SFP+ ports or only the active RSP? I found this information in AS...
Hello everyone,
I am struggling to find information about Rate Limited versions of RSP880 and A9K-MOD200 line cards. Their part numbers are A9K-RSP880-RL-TR and A9K-MOD200RL-TR-B. There is just no information about them in the internen and in open d...
I am facing a problem while installing Cisco Prime Network on Red Hat 6.4The initial installation was OK. It makes me sure the all requirements form Prime Network Gateway were fulfilled.Afterwards the installation script handed the installation over ...
Hello Xander,
Thanks for such an informative and helpful post. Impressive number of views!
I've seen in comments to this post a question from crdiego asking about origin of Aging fail counter. In that output there is one more suspicious counter inc...
Hello,
I've stumbled upon this topic while trying to find out more about ACI simulator. Are there any changes in this respect? Last message is 2 years ago, maybe now it is possible to install it on any server. Or is it still tightly coupled with ser...
Hi Nicolas,
I see there are CGN licenses for line cards:
A9K-800GCGN-LIC=
A9K-400GCGN-LIC=
Do they only enable MAP-T feature on line cards?
Here is a quote from configuration guide:
MAP-T is supported only on Cisco ASR 9000 Series 400G and 200G M...
