Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know how to SSH into a Cisco 7961. Obviously I need a user name and password but I don't know where it needs to be setup. There is no option in the phones config. I am running SCCP version 8-0-4SR3AS
Does anyone know how to SSH into a Cisco 7961. Obviously I need a user name and password but I don't know where it needs to be setup. There is no option in the phones config. I am running SCCP version 8-0-4SR3AS
Does anyone know if I can use the AS5800 system as a SIP gateway? I have looked also at the AS5850, what are the pro's and con's between the AS5800 and the AS5850?
I just turned up a Cisco 7513 and I have about 2 PA-8E modules in a VIP 2-50 card. I have servers connected to these ports and I continue to get massive collisions on every port. I attempted to change the config on the PA-8E to Full Duplex but there...
Yesterday I opend a case with cisco on the RSM and after I told the engineer to read our postings on the forum he said right away that there is a failure with the traffic bus on the RSM. So I got the RSM replaced and I just put the new one in the Cat...
Here is the boot log of the sup:ROM Power Up Diagnostics of Aug 19 1997Init NVRAM LogLED Test ................... doneROM Checksum ............... passedDual Port RAM r/w Test ..... passedID PROM .................... passedSystem DRAM Size(mb) ....
OK,I connected a pc to port 5/1 on vlan 10 with IP address of 10.0.1.5 255.255.255.0 Default gateway of 10.0.1.1Console> (enable) sh port 5/1Port Name Status Vlan Level Duplex Speed Type----- ------------------ ---------- --...
yes, I changed the sup to .2.sc0: flags=63 vlan 1 inet 192.168.1.2 netmask 255.255.255.252 broadcast 192.168.1.3I have the uplink of a HP2524 100FX connected to the 3/1 and off that I have a pc which has the ip address of 10.0.1.5 255.255.255....
