Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've come onto problem switching on BFD on ASR1k.
after applying configuration on router bgp:
neighbor y.y.y.y fall-over bfd single-hop
show bfd neighbors vrf 1001 details show nothing
ASR1K1#sh bfd neighbors vrf 1001 details
ASR1K1#
Please see bel...
Is it possible at nexus 5548 with daughter card to assign ipv6 address to interface?I have gone thru lot's od docs cisco says on tech doc:• IPv6 Routing Protocols: Static, Open Shortest Path First Version 3 (OPFv3), Border Gateway Protocol (BGPv6), E...
Depend how many people would use this network but personally I would use first hop redundancy protocol to asure high availiblity. As Leo said 95m is bit too much for gigaethernet. 1000Base-T should work up to 328 feet. But is only theory.I would see ...
You could use #show queing interface eth 1/1it shows you output similar as below:NEXUS-1# show queuing interface ethernet 1/1Ethernet1/1 queuing information: TX Queuing qos-group sched-type oper-bandwidth 0 WRR 100 RX Q...