Hello,  In CUCM 12.5.1 I've configured a hunt pilot with an 'alerting name' of 'Reception'. The hunt pilot is associated with a Hunt List and the Hunt List is associated with a Line Group. As a test, I made my own DN a member of the Line Group. When ...

Hi all, I've configured a DMZ switch to point to an NTP server on on the Inside, but I get a debug message on the switch that says:NTP: <NTP server IP address> unreachableI'm confident that the NTP server is configured properly, as there are more tha...

Hello, I have one of these routers installed at a remote site. There's only one internet circuit connected to the router (WAN1 interface), so the dual WAN featue is not being used in this case. The internet circuit was recently upgraded from a 2Mb/s ...