Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a router 7606-S is running IOS 12.2 (33r) SRD2 and Internet BGP protocol.I tried to enable Flow Top Talkers on it to check Top 10 flow talkers. 1.configure interface:Router(config-if)#ip flow ingress 2.configureRouter(config)#ip flow-top-talk...
We have 2 border routers (7609-S) running BGP routing protocol with 3 different ISPs and are connecting to 2 ASA5580-40 firewalls (Active-standby mode).A server X on Interent is connecting to our server Y in LAN. Server X is unable to connect to serv...
Hi,I have a ASA 5580 to do site to site VPN with our partner. VPN connection is go through my outside interface and Local LAN for the VPN is from the outside interface too. Is it possible to do it? Thanks.
Hi, I have a IPsec VPN problem. We have a ASA 5580 to build site to site VPN with ALU VPN gateway (from Partner). The VPN connection is not established at all. We checked pair devices configurations but cannot found any problem so far. I tried to do ...
HiWe have 4 devices are running OSPF (3 cisco routers and 1 Juniper firewall as show in attachment file). In last few months, we got Neighbot Down message almost 1-2 times per day. Network between them interrupt for a short time and even monitoring m...
Dear Marvin, Thanks for your advice. After I change local LAN to other interface on firewall, problem is resolved. The request is to connect Remote LAN are using public IP and Local LAN are using private IP(cannot NAT to public IP for technical reaso...
Please refer to topology as attach file I just updated. Actually we have 3 offices (site 1, 2 and 3) are connecting with 10M FTTB link between 2 sites.
We have interupt this morning and CPU utilization of these routers are quite low.CPU utilization:Router A: 5% Router B: 5% Router C: 2%show log:Router AMar 20 01:40:17.252: %OSPF-5-ADJCHG: Process 1, Nbr 172.16.255.128 on GigabitEt...
On the switch between C and D, 3 ports (to C, to D and to A,B switch) were assigned with same vlan.Following interfaces are all configured in subnet 172.16.107.0/24:G0/12 on Router AG0/12 on Router BF0/0/1 on router COutside (to switch) on Firewall D
