Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Scenario:I have a network with 5 ASA 5505. One site is home office (main) and the others are remote locations.Currently all sites have two ISP's, a primary, and a secondary used for fail over.All remote sites have a vpn configured to the main site's ...
I have a cisco 1841 router with two fastethernet interfaces 0/0 and 0/1.Configured 0/0 as outside with 10.10.10.100 255.255.255.0 (network 1) and configured 0/1 as 10.100.100.200 255.255.255.0 (network 2) as inside withIP route 0.0.0.0 0.0.0.0 10.10...
This happens about once a week. The error message means there are packets that are not routable coming in. But why does this keep happening? Is my WAN interface under attack? This happnes about twice a month.
I have copied the config and vlan.dat files via tftp to the computer and want to import them to a replacement switch. Both switches are 2960 model. I get the config over fine but not sure how to get the vlan.dat file to the flash.
I have a switch that accepts the relevant commands to change the vlans, but does not make any changes. I checked that vtp status is server. It is the only switch on this network. It has all ports in the default vlan and all ports are listed in the vo...
There is support for the SG200-50 and SNMP since March 2013 with version 1.3.0.59 Upgrade firmware and bootcode.http://software.cisco.com/download/release.html?mdfid=283771828&softwareid=282463182&release=1.1.2.0 Most recent version with firmware a...
ok I made it worse. I played around witht the routing table. Now I cannot ping devices accross the router. I cannot get to the interent from the 10.100.100.0 network.See config below:=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2013.07.05 12:03:35 =~=~=~=~=~=...
Here is my setup. I can get out to the internet on devices from both networks. I cannot communicate with devices when I cross the router. I need full access to use services like rdp and copying and pasting files. Both networks can ping the router.
The above commands work great aside for the commands for the mangement interface. I could not configure the stateful link, it kept giving me an error. so i gave up to finish the config. See readout below.(again ips changed to 0 for this discussion)....
I am trying to make eth 0/3 the fail over link and using the management 0/0 for stateful info. I wanted to replicate http so the remote users in theory won't know that change happened other than refreshing thier page or so. I was confused on the com...
