Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5508 FTD which I want to manage via a centralized Firepower Management Center server. My problem is that the 5508 will be used to setup the VPN back to the central office. So, how do I setup the s2s vpn on the remote 5508 so that it can...
I have added some AIR-AP2702I-UXK9 APs to a 2504 wlc. The aps are flashing green, red and cannot connect to the a channels. Discovered that these new aps need to be primed to associate the correct country code. I have an LG G4 running 5.1, however I ...
CUCM 9.1 to 10.5 requires a RU which takes over an hour for each server. With six servers (Pub, Sub, CUC1, CUC2, CUP1, CUP2) I am looking at a process of likely 6-10 hours during which services would be up/down intermittently. What I am considering d...
Using an ASA 5545 with web reputation filtering. I have encountered some sites which I want to get to, but have a web reputation below -6. Is there a way to setup exceptions for certain URLs rather than lower the allowed reputation number? Thanks.
I have a remote 3560X switch which has produced the following error messages. Nothing is connected to port 22, none of the other devices require POE from the switch. Port 21 came back online, but not 23 or 24. Any ideas what this refers to and whethe...
Thanks for your help. There was a hardware failure of the inline power controller which requires replacement of the switch to use those ports with POE.
I am planning to reuse the hardware from the 6509 in the 6504E, so it would be identical. However location of the sup would be in a different location since they are currently in slot 5. Hoping that this can be done with little to no down time, but i...
