Hi everyone anyone knows if the meraki wifi solution with another cloud solution like Purple or Cloud4Wi can be integrated with Hotel PMS (Property Management System) to establish the full connection between all the systems Meraki to perform the Wifi connectivity task, the hostpot solution (Purple, Cloud4Wi, etc) the billing and limitations profile and the integration with the PMS. Thanks! ... View more

Any one knowns if is supported uses the RP-TNC to Type N connector  AIR-ACC370-NM-RF= on a 3702E? Regards! ... View more

Hi every one, I started a design where my client ask for the new plataform 5520/8840 WLCs but i can't find information about how config the LAG on both models i just find something about that is no supported LACP and PAgP, i understand that the plataform is based on UCS but, i can't find some config examples and i need to plan my next move talking about the LAN, cause both WLC have 10G ports so my client today have Nexus 5K but as you know Nexus uses VPCs and i don't know if i need to considered other switch like a Cat3850 just for the 10G ports. Kindly regards ... View more

Hi every one, i have a DEMO of Mesh with a 2504 on 7.6 code with 3 1550 the infrastructure works fine on many ways but when i try to connect the cam with the repeater the WLC see one MAC with 2 IPs one of the cam and one of the repeater so the link between the cam and de MESH infrastructure its flapping and dosen`t work.   Anyones know what can i do to support this scenario?     Best Regards! ... View more

Hi everyone im on the middle of a messy thing i have 1  C2921-AX/K9  and 1 WS-C2960X-48TS-L  connected to a RPS with two power supplies of 750watts but when i connect both and test the redundancy with the RPS unplugged the main power supply both the SW and de Router going off, the question is how many power supplies i need in what combination? 750 and 1100 or both of 1100 watts?     Best Regards! ... View more

Hi everyone i have 4 WLC 5508 (2 with 7.4.110 and 2 with 7.4.121) 1 MSE (7.4.110) and 1 CPI (1.3.0.20) with 50 license of wIPS enhanced local mode, all its synch WLCs with CPI and MSE Services with the WLCs, but when i create a new wIPS profile and try to apply to all the WLC or one by one of they i can't to do it, i check the synch services, the NMSP is active and running, the SNMP was config initially with v3 then i changed to v2 with public and private communities like are on the default config on WLCs and all the WLC are reachable and synch on the CPI, but even when i changed the SNMP community and delete the WLCs from the CPI and registered again still the same. Im attached one screenshot of the message.   Hope anyone can't give me some advice or idea.     Best regards!!! ... View more