Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am just looking for an order of operation. If I have an ASA 7.2(2) and I a default global policy. If I make a service policy, and apply it to an interface does that replace the global policy for traffic traversing that interface, or is it like an A...
We have installed a 2811 12.4.6.T1. With the ip inspect %name% http. Is really slowing down web browsering. When I take that command out it is fast. any ideas?
I have a 871w that is setup as ezvpn client and it is dropping packet only to sources across vpn, and only from wireless. I can sit with my wireless pc, and ping the internet and ping a server on the other side of the vpn. The internet will not drop ...
I know it is a little late for an answer but for anyone that may stumble upon this thread later. Nortel made a tool called multicast hammer (or MC Hammer). It works extremely well for testing multicast. It might be a little hard to find with the stat...
If I understand your question correctly. You define and seperate traffic to each context by vlan id's. You would create sub-interfaces in the system context and assign a vlan there. Then assign that sub interface to a context.Example:Eth0/1.10 (Vlan ...
It depends on the version you are running.6.x and older.http://www.cisco.com/en/US/docs/security/pix/pix63/configuration/guide/bafwcfg.html#wp11122267.x and newerhttp://www.cisco.com/en/US/docs/security/asa/asa70/configuration/guide/intparam.html#wp1...
I would say using an acl is more efficient. From previous reading I recall that the acl happens before the route lookup. So you do not want to waste your resources going those extra steps to get to and do a route lookup. Here is a link about NAT orde...
If we are talking the same device in the same security context. I do not think you can. There is support for it if you are running active/active failover.http://www.cisco.com/en/US/docs/security/asa/asa70/configuration/guide/failover.html#wp1102712-J...
