C9200L-48P-4G-E is a PoE switch where C9200L-48T-4G-E is just a data switch. ... View more

Hi,   As mentioned in this thread: https://community.cisco.com/t5/switching/ws-c2960s-48fps-l-stack-port-down/td-p/2160299   Perhaps you should try to reseat stacking modules and cables. I understand that it works on version 12.2(58), but still it may be a periodical issue. I would also try and break the stack and see if the error message appears on both switches. Also I would try to erase all configuration, including vlan.dat etc. and attempt the upgrade again when not in stack. ... View more

No, it was a long time ago. I believe the customer went for another solution. TAC is probably the way to go on this. ... View more

Sorry, no. ... View more

I see, it does not look as if you have this restriction. Regards, Thomas ... View more

Hi Marcio, The ASA 5505 minimum license is DMZ restricted, meaning that you are only able to forward traffic to this zone from 1 other zone, could be outside for example. Please check if you maybe have this license restriction ('sh ver'). Regarding the other issue, you could try posting the configuration commands. Regards, Thomas ... View more

Hi ptyvmsupport, You could try specifying the IP address in hex format. This should result in the following command: dhcpd option 150 hex 0A0A0401 interface ser OR: dhcpd option 150 hex 0x0A0A0401 interface ser Alternatively try leaving the last part of the command out, like so (assuming just one dhcpd instance): dhcpd option 150 ip 10.10.4.1 Regards, Thomas ... View more

Hi LJ, According to the config. guide, this is the procedure for resetting the admin password: Reset the Password If you forget the password for the admin user, another user with CLI Configuration permissions can log in and change the password. If there are no other users with the required permissions, you can reset the admin password from the ASA. The default password differs based on software release; see Defaults for ASA FirePOWER. Before You Begin In multiple context mode, perform this procedure in the system execution space. The password-reset option on the ASA hw-module and sw-module commands does not work with ASA FirePOWER. Procedure Reset the module password for the user admin to the default: session {1 | sfr} do password-reset Use 1 for a hardware module, sfr for a software module. Link: http://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/firewall/asa-94-firewall-config/access-sfr.html#task_A9DDA060A684416491E028387230457C Regards, Thomas ... View more

End customer wants to lock down security on the PC instead of the user so that in case the PC gets stolen, the PC certificate can be revoked. ... View more