Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,
I see that there are 4 tunnels build with different sources (loopbacks) but to the same destinations.
Second thing is that tunnel interfaces are part of vrf but loopack interfaces are not.
Third, tunnel protection ipsec profile is used un...
Why do we need BDPU GUARD and BPDU FILTER both.? I think both are used to protect switch loops ensuring that the port transitions to forwarding state quickly.
Can anyone help me on this.
Thanks
Sukesh Tandon
Hi guys, I have attached a diagram in which i wish to ping from Host A to Host B.Is it possible to do so..If not..why ?? If yes (has it got something to so with native vlan .explain the packet tagging till it reaches switch B). regards Sukesh
multilink bundle-name authenticated.... This command as mentioned in the cisco page is not shown in the running configuration.But i find in the running config of my router. Can anyone explain the difference which the authenticated and endpoint keywor...
hi all, I have attached a diagram can u help me whether all the routers would be able to ping each other. if yes then why ???reason.???if no then also please give a specific reason ...how that ping could be made possible,??? Thankssukesh
yes they will because the destination IP address is same for all of them.
Now to summarize we have default BGP route in the routing table (Global).
1)All the 4 tunnels have different loopback addresses as source and are not part of any VRF.
2) Th...
Yes , the ip cef command shows that it is going via the physical interface.
STPA222#sh ip cef 135.13.15.18
nexthop 90.173.203.233 TenGigabitEthernet0/1/0
So does CEF here tell me which physical interface the packet will go from ?
Thanks!
I get the result as with both global routing table and vrf also .
% Network not in table
So how do i check which is the physical interface that my tunnel has chosen to push the packet from ?
Also could there be any reason for having 4 tunnels
IPSLAs Latest Operation SummaryCodes: * active, ^ inactive, ~ pending
ID Type Destination Stats Return Last (ms) Code Run -----------------------------------------------------------------------*110 http 148.228.140.105 RTT=0 DNS query e 24 seconds ag...
