Hi List,The ATA 187 seems to support Two Lines, but i am unable to configure the Second DN on the phone from CUCM, any idea why not? Thanks in Advance!
Hi,We have CUCM v7.1.5, i have a small question is there a way to update phone/line paramters via Command Line Interface, particularly i am looking for setting up call forwarding? Thanks In Advance!Regards,Mani
Hi All,We have CUCM v7.1 with LDAP integration enabled. I have been trying to get my Nokia E71 register with the CM using SIP, i looked over many documents and followed steps but for some reason am unable to get it done i get messgae 'Un-Authorized' ...
Hi List,We have CCM v7.1.5 with LDAP (Active Directory) sync enabled, all the users are imported, the problem is the integration with LDAP was performed at a later stage (after provisioning around 600 phones). Now we have challenge to assosciate all ...
The direction "In/Out" is in respect to the router and not interface, i.e traffic coming IN our leaving the router, in case of Virtual interface try the ACL in OUT direction and it should work.
Hi,We have CUCM 8.5 and 3900 as MGCP gateway, we are also facing 'Transmission Error' with ATA 187. We have the following configured globally on the gateway:fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711alawWe also upgrad...
Which rom and version of gingerbread are you using. I had the same problem but eversince last update of jabber its working fine now.Regards,Usman TaokeerSent from Mobile Device.