Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dialed Number Analyzer for CUBE
https://cway.cisco.com/tools/DNACube
Tool Description
This tool helps validate Dial-Plan configuration of CUBE (Cisco Unified Border Element) and emulate call routing and number manipulation feature of CUBE....
The Voice Debug Lookup tool provides the most useful debug and show commands used to resolve a given type of voice-related problem. There are many different and distinct categories for a voice problem in a network. This tool clearly identifies the mo...
Yes. If you would like to use 9 dialing, make sure you configure your Route Pattern accordingly and do not strip this digit at Callmanager.Regards,Vinay
Hi,You can try increase the 'Maximum Number of Files' and 'Maximum File Size' values under 'Trace Output Settings'. Default value is 120 files and 1 MB Size.Please note that increasing these values would increase the hard disk usage.Hard disk space...
Hi,Callmanager software MTP do not support G729 codec. It supports only G711alaw and G711ulaw codec. You should use hardware transcoder to support G729 to G711 transcoding.Refer the SRND for more information,http://www.cisco.com/en/US/docs/voice_ip_...
Hi Antra,Your current IOS version supports all the features you looking for,HWIC-2FE Support on 2811http://www.cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd80581fe6_ps5855_Products_Data_Sheet.htmlMFT-E1http://www.cisco.com...
Change the dial-peer config to match actual called number,!dial-peer voice 10 potstrunkgroup LOCALdescription Internationaldestination-pattern 00.Tprefix 00!I assume you have modified the configuration, because i see different called number and prope...
