Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Quick check everyone,presently we don’t have CUCM local and currently codec itself is unreachable from network, can we still proceed to factory reset cts standalone from cli without networking connectivity and without communication to cucm?Thanks and...
We've registered MCU3515 (ver 5.7) both port including EPM to CM successfully and allocated MCU resources to the endpointwe can also place a call from CUVA (ver 2.2 /w cipc 7.0.6) to -> MCU it get connectedand we place another call from CTS500 (ver 1...
2x scenario below between CM <SIP TRUNK> CME, scenario 1 is working, but scenario 2 can it be supported?scenario 1. normal sip trunk (with SRTP allow is working)scenario 2. between CM and CME (secure sip trunk profile not working on CM to CME) <- doe...
Is Secure SRST supported on CIPC 7.x ?? a/ I've tested on ISR 2800 Advanced services K9 12.4(22)T5 (Cisco IOS as CA)b/ with IP Communicator CIPC 7.0.5c/ and UC 8.0.1using below documentation link I've imported all the cert from cm to the router, with...
Systemid user has been created on ACS with full rights to all the lmsappls (all lmsappls has registered successfully also)... there's just 1 more step to complete which is go to lms to *assign device group, however it keep saying active session fo...
oh yes Dpita you mentioned about route leaked,--------------q1. it is leaked to MP-BGP? tenant to tenant running MP-BGP? it is enabledby default MP-BGP or where to enable it for tenant to tenant routing?--------------q2. how and where in menu of the ...
Hi has the endpoint not showing up issue been solved? what's the solution, I am also facing the same issue, I tested on both cpca 9.5 and 9.0, both can discovered add CM (managed) successfully via https, snmp credential, but the Endpoint phone cannot...
Thanks Marwanshawi for the checklist.quick check, in addition to 2x sip trunk, MCU also got to register to CM via SCCP. if not when I place call from CUVA I cannot see CTS from CUVAonce I registered MCU to CM via SCCP, I can see CTS from CUVA. but t...
