Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I've read about the test cable-diagnostics tdr command but I need clarification on the examples listed below to make sure that I am providing the right answer to my co-workers.Example 1:CXXX7SW17#show cable-diagnostic tdr int g0/20 TDR test las...
Hello,The WLC has been recently replaced with a new one and I'm trying to edit the other WLCs in the same location with the new MAC address but I'm getting the following error:Error in deleting pre-existing mobility group member with this address xx....
Hi Everyone!A co-worker of mine was recently involved with swapping out a Cisco 3550 switch with a Cisco 3560-E. For some reason, he wasn't able to ping the switch or connect to it through another switch and all uplinks and trunking was setup correct...
Hello,Is there a way to search for a MAC address of a device that I'm not sure is on the network? The user is not onsite so that person doesn't know what port the device is in. Thanks,Seannetta
Hello,Does anyone know how to configure a Cisco IOS access point to support a Symbol PDT 3146 handheld device? I am getting a lot of roaming and disassociation and I don't know how to fix it. HELP!!!Thanks
There are two switches that couldn't get connected to the network. Both are Cisco 3560E switches and both were uplinked to the appropriate trunks. I could see the interface up for both trunk ports but I couldn't ping them. The protocol status for ei...
Hi Karthick,I didn't think the mls qos was an issue but I wasn't sure. The switch is accessible via Hyperteminal but he couldn't ping the switch through the network and couldn't log into the switch either. Not sure what's going on. The wiring was che...
Hello,I was told by a Cisco tech that if you had special characters in your SSID, when you go to upgrade the access point to another firmware, the SSID goes away. In your reply, you stated to check the SSIDs to see if they match. What is suppose to m...
