Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Guys, I am trying to give whole internet to 3rd pary for one day now the problem is they are on different floor, when I connect internet connection directly to my laptop and assign public IP as vendor provide us its working fine. Due to differen...
Hey Guys, I have VLan that is not load balancing, Users are getting IPs from vlan 10 and when they full they can can't communicate with vlan 20, which is empty Config: Vlan 10: 10.1.1.0/24Vlan 20: 10.1.2.0/24 interface GigabitEthernet1/2/21 descript...
Hey Guys,I have two links on my router; R1 ----- MPLS -----R2 ------------------------------------------1st linkR1-----pt to pt -----R3------MPLS----R2 ---------------------2nd Link by default I am using 1st link and I would like to move to 2nd link,...
Hey Guys, I am trying to configure shared key with EAP and getting error messages, any help will be appreciated. dot11 ssid TEST vlan 860 authentication open eap eap_methods authentication network-eap leap_methods authentication key-manageme...
Hey Guys,I have define policy maping and dont know why its not tagging the IPs; class-map match-all KHAN match access-group name ABC match input-interface GigabitEthernet0/1 ip access-list extended ABC permit ip host 10.11.201.20 10.11.207.128 0.0.0....
I gave this switch port to third party company and they have switch connected to this port thats why this is trunk port. I dont have access to switch but I do know there is no problem on the switch side, only problem is why user are getting IPs in VL...
All Mpls managed by vendor actually, R1 to R1 via MPLS I define the vlan interface and in the vlan interface OSPF cost is 1. on the other side, pt to pt link is very straight its a L3 interface with ospf cost of 1.I have 5 ospf interface I am wonderi...
Thanks for reply Ruggero, as per my little knowledge on class-map; Match-all will match both ACL and Gig 0/1 interface, which I think I have configured already.If I use match-any it wont be a good idea as I need both Gig 0/1 and ACL thats why I use ...
