Hi , As my understanding it will support in both routed and Transparent mode ?What will be the benefits using Routed mode ? or which one should i choose ? We are using this appliance only for IPS and will configure HA between the devices ? #ngips @s...
HI all,
We have pair of Firepower 4120, and need to configure the active/ standby HA for ASA,
Do we have to create first cluster for the Firepower and then add logical device as ASA right ?
Can i get good document to configure this ?
Please assist
we configured voice vlan in one of the cisco 3560 switch and there it is working fine. Now i took an uplink from that switch and connected to my new cisco sg 300, made that port trunk.So now i am in configuring voice vlan for the same in cisco sg300....
Hi,i need to upgrade the IOS of the Switch 4507 with oly one superviser engine(Supervisor 6-E) Model:- WS-4507 R-ECurrent IOS:- cat4500e- ENTSERVICES-M Version 12.2(44)SG1Planing to upgrade :- cat4500e-entservicesk9-mz.152-1.E2.bin Can anybody give ...
The curent ios of switch is :- cat4500-ipbase-mz.122-53.SG1.binI copied the new IOS on the 4948 into the bootflash directory. There is two files, the original and the new img.OLD-HQ-TEMP-SW#show bootflash:-#- ED ----type---- --crc--- -seek-- nlen -le...
@csm_awais No we can't have 3rd switch in stackwise virtual
Secure StackWise Virtual is supported only on two node front-side stacking
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/17-9/configuration_guide/ha/...
Hi @Marvin Rhoads , Thanks for the response,can we use both FPR4K-NM-8X1G-F & FPR9K-NM-6X10SR-F module inorder to get total 7(4+3) Pair inline set (Fail to fire right ) and built in 8*10 G for Management and HA connection ? One more clarification...
Hi Abheesh Kumar, Thanks for the response. So we can configure Active Passive HA in Transparent mode right ? We might have needed 4 inline Pair to inspect different networks.(Include DMZ , Inside,DC traffic ) Can we have 3 inline pair with Bypass mo...