If we had 2 x 2Mb MPLS connections from a single site\subnetwork to a Data Centre could we make use of both of those connections simultaneously? I'm trying to get my head around how it could work, if at all possible?
We have 2 3560 switches connected via fibre using 1000BaseLX sfp modules and fibre cable.One of the switches is constantly having issues with thousands of input errors on the Gigabit Interface and reliability at 160-170/255.The Cisco SDM also reports...
I am having an issue between two routers running HSRP.Both routers are running as being the Active Router. At first i thought that the LAN connection between the two had failed, but they can still both ping each other and when I run "sh cdp neighbors...
I know I've come across this before, but can't remember solution/answer.I am unable to ping a remote server interface from our hub router unless I use extended ping.I can ping from my PC to the server, just not directly from the router (unless using ...
I am trying to set up some of our ADSL Routers with GRE Tunnels but some will not work. On the routers that do not work, the normal ping will does not work to start with. I can ping using the extended ping feature, but a straight forward ping does no...
Hi EdisonThanks for your quick response. If I'm understanding you correctly, would we use one router with one Internal Interface for the LAN but with two External Interfaces, one connected to each MPLS line? And would this traffic be load balanaced?W...
Hi KevinWe have managed to swap out the module at the transmitting end and, so far, we have not seen any errors at the remote switch!!It's been clear of errors for over 19 hours now....so looking good.Thanks very much for your advice.Gary
Hi GlenI will try and get some info to you asap, but, at the moment, I am unable to connect to the switch as we have lost contact with it.I am sending a guy on site to move the module into a different port again!!Gary
Kevin,I must admit that we only concentrated at the end where the errors were occuring. We put in a new switch and purchased new fibre modules.The very strange thing is that we have now moved the module three times, from one gi port to another (port ...
