Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have to set up Prime LMS 4.1 soft appliance to a network containing devices that send syslog messages with facility local.6.Devices logging to 3rd party NMS too, so canging the facility back back to the default value local.7 is not an option.By ...
Hi,I would like to use the Agnet custumization option of NAC 4.8.0.Based on the 'Clean Access Manager Configuration Guide' made the neccesery branding.tar.gz containing the customized nac_logo.gif, nac_login.xml, nac_Srings_xx.xml (in our case here i...
I am using Clean Access 4.7.2.If a user does not mett a requirement and is unable to remediate, he is stucked in the Temporary role.I checked the "Device Management > Clean Access y Reports" but this does not show any user with failed status with red...
I would like to deploy a HA-CAMbased on two 3995 servers. After I set up the HA configuration on both of the servers the primary CAM could no boot up anymore. The Grub failed to boot the Linux. It stucked in state "GRUB Loading stage1.5."What can cou...
Hi,I have been working on the same scenario. Putting serial interface into multilink ppp group the mpls tag switching will be available.!interface Serial0/0:0 no ip address encapsulation ppp ppp multilink ppp multilink group 1!interface Multilink1 m...
Hi Marvin,Thanks for the suggestion.I tried to run the script but it did not solve the problem. After reload the syslog.conf reverted back without the line local.6.Anyway the syslog daemon of the Soft Appliance OS receives and store incoming message...
Hi Federico ,Thanks for your reply.I drawn the same conclusion as you wrote. But this is disaggre with the statement of the configuration guide:"The next time the user authenticates with Cisco NAC Appliance, or if you enforce a mandatory update for t...
