Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
On a C9508, Is there a command which identifies the media type connected on each port. You see, this particular switch uses
SFP's on all ports and depending on the type of SFP, you will use copper or Fibre to connect the end device.
Hop...
Hi,
I have a 3560 running version 15.0(2) SE5 that's showing high utilization.
Here's a sample from command "show proc cpu sor'
PU utilization for five seconds: 83%/2%; one minute: 80%; five minutes: 80% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min...
Hi,
I'm want to identify Corporate devices against BYOD. So, I'm thinking of using condition "WasMachineAuthenticated", Here is my config:
ISE 1.3 Patch 3
Windows 7 Supplicant with Machine and User Auth. Using PEAP.
I have policy for Machine Auth a...
Hi,I'm am using a portal which an AD user or guest user can log in. I'm trying to identify who is login in so I can assign Internet only to a Guest user and Full network access to an AD users. I'm having some difficulty figuring out this part.Has a...
Hi, I read somewhere that ISE v1.3 can create a MAR report.I tried looking into the Report section, but to no avail.Has anyone ever generated this type of report ? Thanks !Tony
Hi Reza,
my bad, I do have the command transceiver, here's a sample:
Ethernet1/5 transceiver is present type is 10Gbase-SR name is CISCO-JDSU part number is PLRXPL-SC-S43-CS revision is 1 serial number is left blank nominal bitr...
Hi Reza, thanks for your response.
Using the command sh interface ex/x capabilities, This is what I see:
Ethernet1/1 is upadmin state is up, Dedicated Interface Belongs to Po11 Hardware: 1000/10000 Ethernet, address: left blank Description: left b...
Hi zma,
I see no one answered your request. I was wondering if you were able to create your Portal with EUP Page only. That's exactly what I'm trying to do.
Thx
Tony
Hi Mady,
As I mentioned on my last post, by following ronniwinge instruction, you will get your sponsor portal working. Now, to your question, unfortunately, my DNS server (Microsoft) doesn't allow me 2 servers pointing to 1 Alias name. I'm not su...
