Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I am facing a strange issue while configuring Cisco WLC 5520 and Cisco 3850 switch.
I have assign IP address 192.168.66.1/24 to WLC Management and untagged it.
Created vlan 66, create SVI assigned IP 192.168.66.254/24. WLC is connected on...
Dear All,
I have 235 APs in the campus. I have 3 WLC appliance(2x4402 and 1x4404) with 200 APs license and a vWLC with 50 APs license.
4400 series appliance have image version 7.0 and vWLC have image version 8.0. All WLCs are in the same mobility gro...
Dear All,
I want to configure QoS for my VC system (Protocol used is h.323). Please advise me to configure QoS step by step. I have attached a diagram.
Thanks,
AS
Dear All, We are planning to buy new routers. We have 2 ISP which should be terminated to a router(now we have 2 router for each ISP), ISP1 speed 75 Mbps and ISP 2 speed 45 Mbps. I want to use both ISP silumteniously with HA.Which router is suitable ...
Dear All,How to configure external database in ACS 4.2 appliance for Windows Active Directory.Active Directory is configured in Windows 2012.ACS internal database is working fine without interruption.What configuration is requred to configure externa...
thanks Rasika, '
it is already disabled. I have attached sh run of 3850.
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
service compress-config
!
hostname Switc...
Thanks Leo,
I have done following 2 steps:
1. Enabled Global AP Failover Priorty under AP Failover Priority.
2. Configured Back-up Primary Controller IP and Back-up Primary Controller name and also configured Back-up Secondary Controller IP and Back...
