We are running Cisco Secure Client 5.1.2 and have a requirement in that if the VPN cannot connect how can I still allow access to say microsoft / 365.Have tried setting the allow access to the following hosts with vpn disconnected in the profile but ...

So got a few C3560CX switches that are hitting the TCAM issue "IPv4 unicast indirectly-connected routes: 1024/1024 1023/1023 "We have a couple of vrf's setup on these switchesWould doing route optimization fix this issue.How easy is this to achieve a...

We have a pair of ASAv in HA running on vmware. there was an issue with the primary so we flipped it over to secondary, but there was issues with the anyconnect clients connecting.The clients were connected but with no connectivity to local resources...

We have just setup a mpls network between 2 datacentres, and now I need to configure xconnect as I have some layer 2 requirements.We have 2 nexus 9364 in a vpc pair connected to 2 catalyst 9500 that are not setup as a pair.  See the diagram.My questi...

Need to add some additional interfaces to a pair of ASAv running on ESX.  (Deleted the original ones when it was initially built)After adding powering down the ASAv and then adding the interfaces, the ASA's boot but I do not get any network access.Th...