Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have assigned a set of "802.1x Supplicant Credentials" to a AP via the controller GUI as showen in the attached picture. Does anyone know how to display/show the 802.1x Supplicant Credentials on the APs CLI ? (As this is for confirmation that t...
Hi I got a new stack comprised of 2pc "C9200L-24P-4G-E" running 16.9.3I´m trying to setup a ERSPAN as descried in the "Command Reference" document (linked below) however none of the need keyworks seems to be supported?! Below are the output, showing ...
Hi All
Anyone
I´m trying to make a setup where guest are isolated into a dedicated guest VRF that breakouts traffic on the local ISP. I almost got the configuration it to a state where it is ready for implementation except for one small issue.
...
Hi
Im trying to make a setup where several VRF´s (In this case called guest) share a single internet connection. The internet connection are in the global routing table.
I have made the route in the VRF pointing to the internet
default gateway
and ...
On a 892FSP router running Version 15.7(3)M1 I get a new type of messages in my log. The router is connected to the internet, with at inbound ACL on the interface, and it runs DMVPN.
I do get all the normal scanning attempts from the internet but a...
Hi I fully agree that the WLC holds and configure APs. I just wished for a option to show the configured credentials in a APs configuration. As the 802.1x credentials are used to "open" the switch port it might be useful in a debug scenario to show t...
Huuumm.... running the Advanced template Will try to change the sdm on monday Switch#show sdm preferShowing SDM Template InfoThis is the Advanced template.Number of VLANs: 1024Unicast MAC addresses: 16384Overflow Unicast MAC addresses: 256L2 Multi...
